.
Features
1. Dimmable integrated COB LED
2. 3W super bright 350 lumen
3. AC 120/230V line voltage input
4. Compact aluminum housing
5. Recess & surface mount design
6. Side & back lead easy to hide cable
The puck light is aluminum housing, solid & endurable, designed for cutout recess and surface mount installation, the finishing is available in white, brushed chrome and black, light color temperature is available in 2700-6500K, color rendering index is 80Ra. Built-in with an integrated dimmable COB LED, line voltage input, attached with 1 meter power cord for hard-cord connection. Dimming compliant with most TRIAC wall mounted dimmer system (10-100% light control). It's lighting performance is excellent for under cabinet, display showcase, ceiling lighting and more.
Integrated COB LED
COB (Chip-On-Board) LED integrated with IC electronics for line voltage input, no transformer required, this LED light is fit into a ceramic cap base, safe and reliable. This LED will consume about 3 watts power, super bright output 350-400 lumen brightness, with the feature of high color rendering index will make it a great choice for indoor lighting applications.
Dimmable
The LED is compliant with most TRIAC (triode alternating current switch) type wall mount dimmer switch systems, it does not require a dimming power supply, the dimmer switch can be directly connected to the LED puck light, smoothly dim the light brightness from 10% to 100%.
RGB LED
This RGB LED light it uses a high power RGB LED built-in on controller PCB, the LED and PCB are built-in the aluminum housing. It comes with a separated infrared remote controller, light colors and RGB changing modes will be controlled by the remote, it need to be pointed to the spotlight front, for the infrared signal receiver is fixed inside.
IR Remote Controller
This RGB LED light it uses a high power RGB LED built-in on controller PCB, the LED and PCB are built-in the aluminum housing. It comes with a separated infrared remote controller, light colors and RGB changing modes will be controlled by the remote, it need to be pointed to the spotlight front, for the infrared signal receiver is fixed inside.
.
Dimensions

Unit dimensions: dia.70 ;
Thickness: 25mm;
Cable: 100cm;
Input voltage: AC 120/230V;
Protection level: IP42, non-waterproof
Installation Instruction
The puck light need hard-wire connection, main power need to be switched off during installation, there are two type of installation, recessed and mounted install. For recessed installation, it will require a cutout of diameter 60mm to fit the puck light, and the base need to be taken off; For mounted installation, it will require two screws to mount the base under cabinet or ceiling.
Recessed Installation

1. Cutout hole Φ60 mm for fitting the puck light;
2. Feed the attached cable to the cutout hole;
3. Fit the puck light into the hole, make sure it is fasten tight with the springs ( take off the base first ).
Mounted Installation

1. Mount the base onto cabinet or ceiling with two screws;
2. Feed the attached cable to the hole on the base;
3. Push the puck light into the base.
Cable lead
1. Lead the attached cable to the side hole of the base, cable visible on the surface;
2. Or lead the cable up to the back of the base, requires a small hole for the cable, cable is hiden invisible on the surface.